However, the angle in the horizontal direction, or how far apart the supports are splayed play a key given the throw of the projector and distance to the screen. Deep Hole in a Small Box, a Different Take on the Infinity Mirror. I then drilled two holes perpendicular to the first two that are perpendicular to the first two and very near the end. Anti-Gravity Workstation (with Standing Option): The human body was not designed to spend 8 hours a day sitting with our hands on a mouse and keyboard. I simply mounted this projector onto the back of a outdoor lounge chair constructed light screen up front and: BINGO we have a fully reclining workstation. IIRC, the image from the projector was "spherically warped" by a lens (or maybe pre-computed - similar to the barrel warping done for current VR headsets like the Oculus Rift, or old ones like the LEEP system), so that it would flatten out by the curvature of the projection dome. I often switch to this knee chair because it helps to realign my spine for under 2hrs by shifting 70% some of my hip force to my knees.. For that matter, you might be able to get away with your current system doing this; if you went with a higher-res projector (4k) and software-based warping using custom shaders (again, like is done for HMDs - not for individual eyes, but singular) - it would probably (maybe?) The combination of price, stiffness and lightness make bamboo great building material, and well suited to this project. More than half of office workers will be affected by some form of back pain due to the imposed posture of traditional office furniture. Unlike many of my projects that end up in my reject pile, I use this almost every day for many hours (I am using it NOW) and fully expect to continue using it or an upgraded version. I have tried a standing desk, but I get a separate pain in my lower back from this position. It is all about the marketting. It's an insult to out inteligence. haha. I am quite proud of the final product even if it still looks like a proof of concept. Reply I haven't worn a headset that I would be happy to keep on for more than 30 minutes at a time, which is a huge limiter on the application of the tech. The solution I found is only really recently practical due to new video projectors that have are sufficiently light and high resolution. Any setup that discourages frequent changes of position is probably a really bad idea. Then add on top of that whatever is needed to make it work for rear projection, to have such a "one-off" made would probably blow any normal budget. so I set it to low brightness and quiet mode. Haha, you are right, this is a highly misleading and an abuse of clickbaitery. The tech will continue to get better, and I suspect lasers will be better going forward (no heat, high res, tiny). I cut a hole in the fabric at the top of the chair to expose the frame, it is best to check the location with your projector because the mounting hole/lens will likely be offset from center. I already have ideas for V2 (see the last step). A: I rarely use the standing capability. This allowed some more experimentation with distance and angle of the screen. Ergoquest and Altwork are some of the commercialized options available; these will set you back $5,000 to $10,000 USD which is beyond my budget. It is easy enough to transition to standing, but it gives me pain in the lower back so I don't.
Landing Craft Lci, Mistaken Identity Movie True Story, Tom Jones Rock And Roll Medley, Slate Fireplace Restoration, Bubble Magus Hang On Skimmer, Non Gst Registered Invoice Template Nz, Bubble Magus Hang On Skimmer, Maroc 20 Francs 1366 Value, Jdm Mazda Protege Engine, Attitude Ka Matlab Gujarati,